Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Installing the internal USB card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.

Steps

  1. Connect the USB key to the internal USB card.
    NOTE:For information on the exact location of USB on system board, see System board jumpers and connectors section
  2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
    Figure 1. Installing the internal USB card

    This image shows the installtion if the internal USB card.

Next steps

  1. Follow the procedure listed in After working inside your system.
  2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\