Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Installing the left control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.

Steps

  1. Align and slide the left control panel assembly in the slot on the system.
  2. Route the left control panel cable through the side wall of the system.
  3. Align and slide the left control panel cable cover in the slot on the system.
    NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
  4. Connect the left control panel cable to the connector on the system board .
  5. Using the Phillips #1 screwdriver, tighten the screws to secures the left control panel and the cable cover to the system.
    NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the left control panel
    This image shows the installation of the left control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\