Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Installing the MicroSD card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
NOTE:To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:Ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.

Steps

  1. Locate the MicroSD card slot on the IDSDM module. Orient the MicroSD card appropriately and insert the contact-pin end of the card into the slot. To locate IDSDM, see the System board jumpers and connectors section.
    NOTE:The slot is keyed to ensure correct insertion of the card.
  2. Press the card into the slot to lock it into place.
    Figure 1. Installing the MicroSD card
    This image shows how to install the MicroSD card.

Next steps

  1. Install the IDSDM module.
  2. Follow the procedure listed in the After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\