Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Removing the drive from the drive carrier

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Remove the drive carrier

Steps

  1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
    NOTE: If the drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to remove the drive.Torx screw image
  2. Lift the drive out of the drive carrier.
    Figure 1. Removing the drive from the drive carrier
    This image shows removing the drive from the drive carrier

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\