Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Removing the left control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud.
  4. Remove the drive backplane cover.
  5. Remove the cooling fan cage assembly.

Steps

  1. Disconnect the control panel cable from the system board connector.
    NOTE:Observe the routing of the cable as you remove it from the system.
  2. Using the Phillips #1 screwdriver, remove the screws that secure the cable cover and left control panel assembly to the system.
  3. Remove the cable cover away the system.
  4. Holding the left control panel assembly , remove the control panel along with the cable from the system.
    Figure 1. Removing the left control panel
    This image shows the removal of the left control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\