Dell EMC PowerEdge R550 Installation and Service Manual

PDF

Removing the system cover

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Power off the system, and any attached peripherals.
  3. Disconnect the system from the electrical outlet and peripherals.

Steps

  1. Using a 1/4-inch flat head or Phillips #2 screwdriver, rotate the lock counterclockwise to the unlock position.
  2. Lift the release latch until the system cover slides back.
  3. Lift the cover from the system.
    Figure 1. Removing the system cover

    This image shows the removal of system cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\