Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

serialcapture

Table 1. Details of serialcaptureThe following table provides details about the serialcapture subcommand:
serialcapture
Description The serialcapture subcommand is used to is used to export and clear serial data captured from the system. To run this subcommand, you must have the following privileges:
Synopsis
NOTE:To run clear and export commands, the target server must have iDRAC Datacenter license.
To clear serial data. 
racadm serialcapture clear
To export serial data. 
racadm serialcapture export -u <shareuser> -p <sharepassword> -l <NFS/CIFS/HTTP/HTTPS share> -f <FileName>
Input
  • -f—Filename of the exported serial data.
  • -u—Username of the remote share to where the file must be exported. The username must be specified as domain/username.
  • -p—Password for the remote share to where the file must be exported.
  • -l—Network share location to where the serial data captured must be exported. For more information on NFS or CIFS or HTTP or HTTPS share, see section on Usage examples.
Example To clear serial data buffer. 
racadm serialcapture clear
To export serial data to CIFS share. 
racadm serialcapture export -u cifsuser -p cifspassword -l //1.2.3.4/cifsshare -f datafile
To export serial data to NFS share. 
racadm serialcapture export -u nfssuser -p nfspassword -l 1.2.3.4:/nfsshare -f datafile
To export serial data to HTTP share. 
racadm serialcapture export -u httpuser -p httppassword -l http:/1.2.3.4/httpshare -f datafile
To export serial data to HTTPS share. 
racadm serialcapture export -u httpsuser -p httpspassword -l https:/1.2.3.4/cifsshare -f datafile

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\