Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

setled

Table 1. Details of setled The following table provides details about the setled subcommand:
setled
Description Sets the state (blinking or not blinking) of the LED on the specified module. To run this subcommand, you must have the Configure iDRAC permission.
Synopsis 
racadm setled -l <ledState>
Input
  • -l <ledState> — Specifies the LED state. The values are:
    • 0 — No Blinking
    • 1 — Blinking
Example
  • From iDRAC stop LED from blinking. 
    racadm setled -l 0
RAC0908: System ID LED blink off.
  • From iDRAC start LED to blink. 
    racadm setled -l 1
RAC0907: System ID LED blink on.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\