Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R740 Installation and Service Manual

PDF

Installing NVDIMM-N battery into mid drive tray

Prerequisites

Follow the safety guidelines listed in Safety instructions.

CAUTION:NVDIMM-N battery is not hot swappable. To prevent data loss and potential damage to your system, ensure that your system, LEDs on system, LEDs on NVDIMM-N and LEDs on NVDIMM-N battery are turned off before installing the NVDIMM-N battery.
CAUTION:To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.

Steps

  1. Connect the cables to the NVDIMM-N battery.
  2. Slide the NVDIMM-N battery to engage the battery with the drive tray.
  3. Using Phillips #2 screwdriver, tighten the screw to secure the NVDIMM-N battery.
  4. Lower the drive tray handle.
    Figure 1. Installing NVDIMM-N battery into mid drive tray
    This image shows installing NVDIMM-N battery into mid drive tray.

Next steps

Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\