Dell EMC PowerEdge R740 Installation and Service Manual

System health and system ID indicator codes

The system health and system ID indicator is located on the left control panel of your system.

Table 1. System health and system ID indicator codesThis table describes the system health and system ID indicators. Item 1 indicates Solid blue where the condition indicates that the system is turned on, system is healthy, and system ID mode is not active. Press the system health and system ID button to switch to system ID mode. Item 2 indicates Blinking blue where the condition indicates that the system ID mode is active. Press the system health and system ID button to switch to system health mode. Item 3 indicates solid amber where the condition indicates that the system is in fail-safe mode. If the problem persists, see the Getting help section. Item 4 indicates blinking amber where the condition indicates that the system is experiencing a fault. Check the System Event Log or the LCD panel, if available on the bezel, for specific error message.
For more information about error messages, see the *Event and Error Message Reference Guide for 14th Generation Dell EMC PowerEdge Servers* at www.dell.com/qrl.
System health and system ID indicator code	Condition
Solid blue	Indicates that the system is turned on, system is healthy, and system ID mode is not active. Press the system health and system ID button to switch to system ID mode.
Blinking blue	Indicates that the system ID mode is active. Press the system health and system ID button to switch to system health mode.
Solid amber	Indicates that the system is in fail-safe mode. If the problem persists, see the Getting help section.
Blinking amber	Indicates that the system is experiencing a fault. Check the System Event Log or the LCD panel, if available on the bezel, for specific error messages. For more information about error messages, see the Event and Error Message Reference Guide for 14th Generation Dell EMC PowerEdge Servers at www.dell.com/qrl.