The software security features of the system include a system password and a setup password. The password jumper enables or disables password features and clears any password(s) currently in use.
Prerequisites
CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Steps
Power off the system, and all the attached peripherals, and disconnect the system from the electrical outlet.
Remove the system cover.
Move the jumper on the system board from pins 2 and 4 to pins 4 and 6.
Replace the system cover.
NOTE:The existing passwords are not disabled (erased) until the system boots with the jumper on pins 4 and 6. However, before you assign a new system and/or setup password, you must move the jumper back to pins 2 and 4.
NOTE:If you assign a new system and/or setup password with the jumper on pins 4 and 6, the system disables the new password(s) the next time it boots.
Reconnect the system and all the attached peripherals.
Power off the system.
Remove the system cover.
Move the jumper on the system board from pins 4 and 6 to pins 2 and 4.
Replace the system cover.
Reconnect the system to the electrical outlet and power on the system, and all the attached peripherals.
Assign a new system and/or setup password.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\