Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Installing the GPU air shroud

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the tabs on the air shroud with the slots on the system.
    Figure 1. Installing the GPU air shroud
    This image shows how to install the GPU air shroud
  2. Lower the air shroud into the system until it is firmly seated.
  3. Install the expansion card riser 1 and 2.
  4. If applicable, install the NVDIMM-N battery.
  5. Holding the blue touch point on the air shroud cover, incline the cover at an angle, and then push it down until it is firmly seated.
    Figure 2. Installing the GPU air shroud cover
    This image shows how to install the GPU air shroud cover.

Next steps

  1. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\