Dell EMC PowerEdge R840 Installation and Service Manual

PDF

GPU card installation guidelines

  • Ensure that both the processors are installed.
  • The processor must use the GPU kit low-profile heat sink.
  • To ensure adequate cooling when one or more GPUs are installed, the ambient inlet temperature is restricted to 30°C for CPU 150 W/8 C, 165 W/12 C, 200 W, 205 W. For more information, see the Ambient temperature limitations section in the PowerEdge R840 Technical Specs at www.dell.com/poweredgemanuals..
  • All GPUs must be of the same type and model.
  • The cover on the GPU air shroud must be removed before installing the GPU.
  • Ensure that high performance fans and GPU air shroud are installed.
NOTE When using systems with GPU, ensure that you install PSUs with 1100 W or higher, and set the PSU configuration to non-redundant mode.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\