Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Installing IDSDM or vFlash module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the expansion card riser 1.

Steps

  1. Locate the IDSDM or vFlash connector on riser 1.
  2. Align IDSDM or vFlash module with the connector on the riser.
  3. Push IDSDM or vFlash module until it is firmly seated in the connector on the riser.
    Figure 1. Installing IDSDM or vFlash module
    This image shows how to install the IDSDM or VFlash module

Next steps

  1. Install the microSD cards.
    NOTE Reinstall the microSD cards into the same slots based on the labels you had marked on the cards during removal.
  2. Install the expansion card riser 1.
  3. Install the air shroud.
  4. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\