Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Installing left control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the non-GPU air shroud or GPU air shroud.
  4. Remove the cooling fan assembly.
NOTE Ensure that you note the routing of the cables as you remove them from the system board. To prevent the cables from being pinched or crimped, you must route the cables properly when you replace them.

Steps

  1. Route the control panel cable through the side wall of the system.
  2. Align the control panel assembly with the control panel slot on the system and attach the control panel assembly to the system.
  3. Connect the control panel cable to the system board connector.
  4. Close the cable latch to secure the control panel cable.
  5. Using a Phillips #1 screwdriver, install the screws that secure the control panel and ribbon cable to the system.
    Figure 1. Installing left control panel
    This image shows how to install left control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\