Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Installing network daughter card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the expansion card riser 1.

Steps

  1. Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
  2. Align the captive screws on the card with the screw holes on the system board.
  3. Press the touch points on the card until the card connector is firmly seated on the system board connector.
  4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
    Figure 1. Installing the network daughter card
    This images shows how to install the network daughter card

Next steps

  1. Install the expansion card riser 1 or the rear drive cage, depending on the configuration of your system.
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\