Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Installing power supply unit

The procedure for installing AC and DC PSUs is identical.

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. For systems that support redundant PSU, ensure that both the PSUs are of the same type and have the same maximum output power.
    NOTE The maximum output power (shown in watts) is listed on the PSU label.

Steps

Slide the PSU into the system until the PSU is fully seated and the release latch snaps into place.
Figure 1. Installing power supply unit
This image shows installing a power supply unit.

Next steps

  1. If you have removed the strain relief bar attachment bracket and strain relief bar, reinstall them. For information about the strain relief bar attachment bracket and strain relief bar, see the system’s Rail Installation Guide at https://www.dell.com/poweredgemanuals.
  2. Connect the power cable to the PSU, and plug the cable into a power outlet.
    CAUTION When connecting the power cable to the PSU, secure the cable to the PSU with the strap.
    NOTE When installing, hot swapping, or hot adding a new PSU, wait for 15 seconds for the system to recognize the PSU and determine its status. The PSU redundancy may not occur until discovery is complete. Wait until the new PSU is discovered and enabled before you remove the other PSU. The PSU status indicator turns green to signify that the PSU is functioning properly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\