Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Installing the non-GPU air shroud

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the tabs on the air shroud with the slots on the system.
  2. Lower the air shroud into the system until it is firmly seated.
    Figure 1. Installing the non-GPU air shroud
    This image shows how to install the non-GPU air shroud.

Next steps

  1. If applicable, install the NVDIMM battery.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\