Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Installing USB 3.0 module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the cooling fan assembly.

Steps

  1. Route the power and the USB cables on the USB 3.0 module through the USB 3.0 module slot on the front of the system.
  2. Insert the USB 3.0 module into the slot on the front panel.
  3. Align the screw on the module with the screw hole on the system.
  4. Using a Phillips #2 screwdriver, tighten the screw to secure the module to the system.
  5. Route and connect the USB cable to internal USB port and power cable to the backplane power connector on the system board. To locate the connector, see the System board jumpers and connectors section.
    Figure 1. Installing USB 3.0 module
    This image shows how to install the USB 3.0 module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\