Dell EMC PowerEdge R840 Installation and Service Manual
Options to set up iDRAC IP address
To enable communication between your system and iDRAC, you must first configure the network settings based on your network infrastructure.
NOTE For static IP configuration, you must request for it at the time of purchase.
This option is set to DHCP by Default. You can set up the IP address by using one of the following interfaces:
- Interfaces
- Document/Section
- iDRAC Settings utility
- Dell Integrated Dell Remote Access Controller User's Guide at www.dell.com/poweredgemanuals
- Dell Deployment Toolkit
- Dell Deployment Toolkit User’s Guide at www.dell.com/openmanagemanuals > OpenManage Deployment Toolkit
- Dell Lifecycle Controller
- Dell Lifecycle Controller User’s Guide at www.dell.com/poweredgemanuals
- Server LCD panel
- LCD panel section
- iDRAC Direct and Quick Sync 2 (optional)
- See Dell Integrated Dell Remote Access Controller User's Guide at www.dell.com/poweredgemanuals
NOTE To access iDRAC, ensure that you connect the ethernet cable to the iDRAC9 dedicated network port. You can also access iDRAC through the shared LOM mode, if you have opted for a system that has the shared LOM mode enabled.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\