Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Removing a power supply unit blank

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

If you are installing a second PSU, remove the PSU blank in the bay by pulling the blank outward.
CAUTION To ensure proper system cooling, the PSU blank must be installed in the second PSU bay in a non-redundant configuration. Remove the PSU blank only if you are installing a second PSU.
Figure 1. Removing a power supply unit blank
This image shows removing power supply unit blank.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\