Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Removing IDSDM or vFlash module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the expansion card riser 1.

Steps

  1. Locate the IDSDM or vFlash connector on riser 1.
  2. Holding the pull tab, lift the IDSDM or vFlash module out of the system.
    Figure 1. Removing IDSDM or vFlash module
    This image shows how to remove the IDSDM or vFlash module
    NOTE There are two dip switches on the IDSDM or vFlash module for write-protection.
    NOTE If you are replacing the IDSDM or vFlash module, remove the microSD cards.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\