Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Removing left control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the non-GPU air shroud or GPU air shroud.
  4. Remove the cooling fan assembly.
    NOTE Ensure that you note the routing of the cables as you remove them from the system board. To prevent the cables from being pinched or crimped, route the cables properly when you replace them.

Steps

  1. Open the cable latch, and disconnect the control panel cable from the system board connector.
  2. Using a Phillips #1 screwdriver, remove the screws that secure the control panel and ribbon cable to the system.
  3. Holding the control panel and ribbon cable, remove the control panel along with the ribbon cable away from the system.
    Figure 1. Removing left control panel
    This image shows how to remove the left control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\