Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Removing network daughter card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the expansion card riser 1.

Steps

  1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
  2. Hold the NDC by the edges, and lift to disengage it from the connector on the system board.
  3. Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back of the system.
    Figure 1. Removing network daughter card
    This image shows how to remove the network daughter card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\