Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Removing the GPU air shroud

Prerequisites

CAUTION Never operate your system with the air shroud removed. The system may get overheated quickly, resulting in shutdown of the system and loss of data.
  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Holding the air shroud cover at the blue touch point, lift the cover at an angle to disengage it from the air shroud, and then lift it away from the system.
    Figure 1. Removing the GPU air shroud cover
    This image shows how to remove the GPU air shroud cover
  2. If installed, remove the NVDIMM-N battery.
  3. Remove the expansion card riser 1 and 2.
  4. Hold the air shroud and lift it away from the system.
    Figure 2. Removing the GPU air shroud
    This image shows how to remove the GPU air shroud

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\