Dell EMC PowerEdge R840 Installation and Service Manual

PDF

Removing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. If installed, remove the rear drive cage.
  5. Remove the BOSS card.
    NOTE The procedure to remove the BOSS card is similar to the removing an expansion card.

Steps

  1. Loosen the screw and lift the retention strap that secures the M.2 SSD module on the BOSS card.
  2. Lift the M.2 SSD module and slide it out of the connector on the BOSS card.
    Figure 1. Removing the M.2 SSD module
    This image shows how to remove the M.2 SSD module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\