You can access the following components from the back of the system:
Figure 1. Back view features . This image shows back view features.
Table 1. Features available on the back of the systemThe following table provides information about the features available on the back of the system.
Item
Slot, button, or connector
Icon
Description
1
expansion card riser (right)
N/A
The expansion card riser (right) supports up to three full-height PCI Express expansion cards. For more information, see the Expansion card installation guidelines section.
2
expansion card slot
N/A
The expansion slots on the system board supports full-height half-length PCI Express expansion cards.
3
NIC port (4)
The
NIC ports that are integrated on the network daughter card (NDC) provide
network connectivity. For more information about the supported configurations,
see the Technical specifications section.
4
expansion card riser (left)
N/A
The expansion card riser (left) supports up to three full-height PCI Express expansion cards. For more information, see the Expansion card installation guidelines section.
5
Power supply unit (2)
For more information, see the Technical specifications section.
6
Video port
Enables you to connect a display device
to the system. For more information, see the Technical specifications
section.
7
Serial port
Enables you to connect a serial device
to the system. For more information, see the Technical specifications
section.
8
iDRAC9 Enterprise port
Enables you to remotely
access iDRAC. For more information, see the iDRAC User’s Guide at www.dell.com/poweredgemanuals.
9
USB port (2)
The USB ports are 9-pin, USB 3.0-compliant. These ports enable you to connect USB devices to the system.
10
System identification button
The System Identification
(ID) button is available on the front and back of the systems. Press the button
to identify a system in a rack by turning on the system ID
button. You can also use the system ID button to reset iDRAC and to
access BIOS using the step through mode.
11
System status indicator cable port
Enables you to connect the status indicator cable and view system status when the CMA is installed.
For more information, see the
Dell EMCPowerEdgeR940 Technical Specifications on the product documentation page.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
