Dell PowerEdge R940 Installation and Service Manual

PDF

Installing the NDC riser

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Hold the Network Daughter Card (NDC) riser by its edges and align the connector on the NDC riser and guide pin on the system board.
  2. Insert the NDC riser until the card is fully seated.
  3. Close the riser retention bracket and slide the bracket to lock the NDC riser.
    Figure 1. Install the NDC riser
    This image shows installing the NDC riser.

Next steps

  1. Connect the cables to the NDC riser.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\