Dell PowerEdge R940 Installation and Service Manual

PDF

Installing optional IDSDM module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Locate the IDSDM module on the system board.
    To locate IDSDM module, see the System board jumpers and connectors section.
  2. Align the IDSDM module with the connector on the system board.
  3. Push the IDSDM module until it is firmly seated on the system board.
    Figure 1. Installing optional IDSDM module
    This image shows how to install the optional IDSDM or vFlash module.

Next steps

  1. Install the MicroSD cards.
    NOTE:Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during removal.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\