Dell PowerEdge R940 Installation and Service Manual

PDF

Installing the air shroud

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. To install the air shroud in a two processor configuration system:
    1. Lower the air shroud into the system until it is firmly seated.
      When firmly seated, the memory socket numbers marked on the air shroud align with the respective memory sockets on the system board.
      Figure 1. Installing the air shroud — Two processor system
      This image shows installing the air shroud for two processor system.
  2. To install the air shroud in a four processor configuration system:
    1. Align the slots on the air shroud with the tabs on the processor expansion module (PEM) handle.
    2. Lower the air shroud into the system until it is firmly seated.
      When firmly seated, the memory socket numbers marked on the air shroud align with the memory sockets on the PEM.
    3. Press the blue touch point to ensure that the air shroud is seated firmly.
    4. Unhook the expansion card riser from the side of the system.
    5. Install the expansion card risers. See Installing the expansion card riser.
    Figure 2. Installing the air shroud — Four processor system
    This image shows installing the air shroud for four processor system.

Next steps

  1. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\