Dell PowerEdge R940 Installation and Service Manual

PDF

Installing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the M.2 SSD module connectors with the connectors on the BOSS card.
  2. Push the M.2 SSD module until the module is seated firmly on the BOSS card.
  3. Secure the M.2 SSD module on the BOSS card with the retention straps and screws.
    Figure 1. Installing the M.2 SSD module
    This image shows how to install M.2 SSD module.

Next steps

  1. Install the BOSS card.
    NOTE:Installing the BOSS card is similar to installing the expansion card riser.
  2. Install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\