Dell PowerEdge R940 Installation and Service Manual

PDF

Installing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Route the cables through the cable routing hooks on the side of the system.
  2. Lower the cable management bracket into the system.
  3. Press the bracket and insert the tabs on the bracket into the slots on the right side of the system.
  4. Align the control panel with the control panel slot on the system and attach the control panel to the system.
  5. Connect the control panel cable connector on the system board.
  6. Using a Torx #T30 screwdriver, install the screws that secure the control panel to the system.
    Figure 1. Installing the right control panel
    This image shows installing the right control panel.

Next steps

  1. Lift the sides of the fan tray until the blue release tabs click in place.
  2. If removed, install the expansion card risers
  3. If removed, install the PEM.
  4. Install the air shroud.
  5. Install the fan cage.
  6. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\