Dell PowerEdge R940 Installation and Service Manual

PDF

Installing the system cover

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system.

Steps

  1. Align the tabs on the system cover with the guide slots on the system.
  2. Push the system cover latch down.
    The system cover slides forward, the tabs on the system cover engage with the guide slots on the system and the system cover latch locks into place.
  3. Using a 1/4 inch flat head or Phillips #2 screwdriver, rotate the latch release lock clockwise to the locked position.
    Figure 1. Installing the system cover
    This image shows installing the system cover

Next steps

  1. Reconnect the peripherals and connect the system to the electrical outlet.
  2. Power on the system, including any attached peripherals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\