Dell PowerEdge R940 Installation and Service Manual

PDF

Removing a drive blank

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. If installed, remove the front bezel.
CAUTION:To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION:Mixing drive blanks from previous generations of PowerEdge servers is not supported.

Steps

Press the release button, and slide the drive blank out of the drive slot.
Figure 1. Removing a drive blank
The image shows removing drive blank

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\