Dell PowerEdge R940 Installation and Service Manual

PDF

Removing a power supply unit blank

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

If you are installing a second power supply unit, remove the power supply unit blank in the bay by pulling the blank outward.
CAUTION:To ensure proper system cooling, the power supply unit blank must be installed in the second power supply unit bay in a non-redundant configuration. Remove the power supply unit blank only if you are installing a second power supply unit.
Figure 1. Removing a power supply unit blank
This image shows removing power supply unit blank.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\