Dell PowerEdge R940 Installation and Service Manual

PDF

Removing an intrusion switch

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the fan cage.
  4. Remove the air shroud.
  5. If applicable, remove the expansion card risers.
  6. Remove the PEM.
  7. Press the blue release tabs on the fan tray and lower the sides of the tray.
  8. Disconnect the cable connected to the intrusion switch connector (INTRUSION) on the system board.

Steps

  1. Press the cable management bracket down until the tabs on the bracket disengage from the slots on the side of the system.
  2. Lift the cable management bracket out of the system.
  3. Press the tab on the intrusion switch cable connector and disconnect the cable connected to the intrusion switch connector (INTRUSION) on the system board.
  4. Remove the cables routed through the cable routing hooks on the right side of the system.
  5. Push the intrusion switch out of the intrusion switch slot.
    Figure 1. Removing an intrusion switch
    This image shows removing an intrusion switch.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\