Dell PowerEdge R940 Installation and Service Manual

PDF

Removing the expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Disconnect any cables connected to the expansion card.

Steps

  1. Lift the release lever until the connector on the riser disconnects from the connector on the processor expansion module (PEM).
  2. Lift the riser away from the system.
    Figure 1. Removing expansion card riser (right). This image shows removing expansion card riser.
    This image shows removing the expansion card riser (right).
    Figure 2. Removing expansion card riser (left)
    This image shows removing the expansion card riser (left).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\