Dell PowerEdge R940 Installation and Service Manual

PDF

Removing the NDC riser

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Disconnect the cables connected to the Network Daughter Card (NDC) riser.

Steps

  1. Slide the riser retention bracket to unlock the NDC riser.
  2. Hold the NDC riser by its edges, and pull the NDC riser until the card edge connector disengages from the connector on the system board.
  3. Lift the NDC riser from the system.
    Figure 1. Removing the NDC riser
    This image shows removing the NDC riser.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\