Dell PowerEdge R940 Installation and Service Manual

PDF

Removing the NDC

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the Network Daughter Card (NDC) riser.

Steps

  1. Using a Phillips #2 screwdriver, loosen the captive screws that secure the NDC to the NDC riser.
  2. Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the NDC riser.
  3. Slide the NDC away from the NDC riser bracket until the Ethernet connectors are clear of the slot in the NDC riser.
    Figure 1. Removing the NDC
    This image shows removing the NDC.

Next steps

  1. Install the NDC.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\