Dell PowerEdge R940 Installation and Service Manual

PDF

Removing the optional IDSDM module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If you are replacing the IDSDM module, remove the MicroSD cards.
    NOTE:Temporarily label each MicroSD card with its corresponding slot number after removal.

Steps

  1. Locate the IDSDM module connector on the system board.
    To locate IDSDM module connector, see the System board jumpers and connectors section.
  2. Holding the pull tab, lift the IDSDM module out of the system.
    Figure 1. Removing the optional IDSDM module
    This image shows how to remove the optional IDSDM or vFlash module.
    NOTE:There are two dip switches on the IDSDM module for write-protection.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\