Dell PowerEdge R940 Installation and Service Manual

PDF

Removing the PEM

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the expansion card risers.
  4. Remove the air shroud.

Steps

  1. Lift the PEM using the handle until the PEM is in an upright position.
  2. Press the release latch on the cable and disconnect the cables connected to the connectors on the PEM.
  3. Press the release latch on the side of the chassis and lift the PEM out of the system.
    Figure 1. Removing the PEM
    This image shows removing the PEM.

Next steps

Install the PEM.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\