Dell PowerEdge R940 Installation and Service Manual

PDF

Removing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the fan cage.
  4. Remove the air shroud.
  5. If installed, remove the expansion card risers.
  6. If installed, remove the PEM.
    NOTE:Ensure that you note the routing of the cables as you remove them from the system board. You must route the cables properly when you replace them to prevent the cables from being pinched or crimped.
  7. Press the blue release tabs on the fan tray and lower the sides of the tray.

Steps

  1. Press the cable management bracket until the tabs on the bracket disengage from the slots on the right side of the system and lift the cable management bracket from the system.
  2. Holding the pull tab, disconnect the control panel cable from the system board.
  3. Using a Torx #T30 screwdriver, remove the screws that connect the control panel to the system.
  4. Holding the control panel by its sides, remove the control panel away from the system.
    Figure 1. Removing the right control panel
    This image shows removing the right control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\