Dell PowerEdge R940 Installation and Service Manual

PDF

Removing the storage controller card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the Network Daughter Card (NDC) riser.

Steps

  1. Slide the riser retention bracket to unlock the storage controller card.
  2. Hold the storage controller card by its edges and lift to remove it from the connector on the system board.
  3. Press the release tab on the SAS cable connector to disconnect the cable from the storage controller card.
    Figure 1. Removing the storage controller card
    This image shows removing the storage controller card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\