Dell PowerEdge R940 Installation and Service Manual

PDF

System board jumper settings

For information on resetting the password jumper to disable a password, see the Disabling a forgotten password section.

Table 1. System board jumper settingsSystem board jumper settings.
JumperSettingDescription
PWRD_ENThe figure shows jumper pin settings when the BIOS password feature is enabled.The BIOS password feature is enabled.
The figure shows jumper pin settings when the password feature is disabled.The BIOS password feature is disabled. iDRAC local access is unlocked at next AC power cycle. iDRAC password reset is enabled in F2 iDRAC settings menu.
NVRAM_CLRThe figure shows jumper pin settings when the BIOS configuration settings are retained at system boot.The BIOS configuration settings are retained at system boot.
The figure shows jumper pin settings when the BIOS configuration settings are cleared at system boot.The BIOS configuration settings are cleared at system boot.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\