- Notes, cautions, and warnings
- Overview
- Accessing the command prompt
- Working with the PERC Command Line Interface tool
- System commands
- Controller commands
- Drive commands
- Virtual drives commands
- Add virtual drives commands
- Delete virtual drives commands
- Delete Non-RAID disks
- Virtual drive show commands
- Preserved cache commands
- Change virtual drive properties commands
- Virtual drive initialization commands
- Virtual drive erase commands
- Virtual drive migration commands
- Virtual drive consistency check commands
- Background initialization commands
- Virtual drive expansion commands
- Foreign configurations commands
- BIOS-related commands
- Drive group commands
- BBU commands
- Enclosure commands
- PHY commands
- Logging commands
- PERC CLI command examples
- Getting a complete list of CLI commands
- Checking controller availability
- Viewing controllers
- Viewing free space information
- Viewing disk1 information
- Viewing controller, virtual disk, and drivers information
- Checking for preserved cache
- Deleting preserved cache
- Viewing expansion information
- Viewing the foreign configuration
- Importing the foreign configuration
- Viewing BBU information
- Viewing physical drive details for the specified slot in the controller
- Viewing the boot drive for the controller
- Setting virtual drive as boot drive
- Locating a drive
- Stopping a locate operation
- Snapdump commands
- Getting help
Dell EMC PowerEdge RAID Controller CLI Reference Guide
Drive security commands
The PERC Command Line supports the following drive security command:
perccli /cx[/ex]/sx show securitykey keyid
This command shows the security key and key ID of the controller.
Input example:
perccli /c0/s4 show securityKey keyidperccli /cx[/ex]/sx set security=on
This command sets the security key on JBOD or Non-RAID disks.
Input example:
perccli /c0/e2/s4 set security=onperccli /cx[/ex]/sx show jbod
This command shows the summary of the non-RAID disks/JBOD drive for specified slot in the controller.
Input example:
perccli /c0/e2/s4 show jbodperccli /cx[/ex]/sx show jbod all
This command shows all information of a non-RAID disks/JBOD drive for the specified slot in the controller. The all option in the command shows information for all slots on the controller. x stands for a number, a list of numbers, a range of numbers, or all numbers.
Input example:
perccli /c0/e2/s4 show jbod all Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\