- Notes, cautions, and warnings
- Overview
- Accessing the command prompt
- Working with the PERC Command Line Interface tool
- System commands
- Controller commands
- Drive commands
- Virtual drives commands
- Add virtual drives commands
- Delete virtual drives commands
- Delete Non-RAID disks
- Virtual drive show commands
- Preserved cache commands
- Change virtual drive properties commands
- Virtual drive initialization commands
- Virtual drive erase commands
- Virtual drive migration commands
- Virtual drive consistency check commands
- Background initialization commands
- Virtual drive expansion commands
- Foreign configurations commands
- BIOS-related commands
- Drive group commands
- BBU commands
- Enclosure commands
- PHY commands
- Logging commands
- PERC CLI command examples
- Getting a complete list of CLI commands
- Checking controller availability
- Viewing controllers
- Viewing free space information
- Viewing disk1 information
- Viewing controller, virtual disk, and drivers information
- Checking for preserved cache
- Deleting preserved cache
- Viewing expansion information
- Viewing the foreign configuration
- Importing the foreign configuration
- Viewing BBU information
- Viewing physical drive details for the specified slot in the controller
- Viewing the boot drive for the controller
- Setting virtual drive as boot drive
- Locating a drive
- Stopping a locate operation
- Snapdump commands
- Getting help
Dell EMC PowerEdge RAID Controller CLI Reference Guide
Drive show commands
The PERC Command Line Tool supports the following drive show commands:
perccli /cx[/ex]/sx show perccli /cx[/eall]/sall show perccli /cx[/ex]/sx|sall show all perccli /cx[/ex]/sall show jbod perccli /cx[/ex]/sx show jbod
NOTE: If enclosures are used to connect physical drives to the controller, specify the enclosure ID in the command. If no enclosures are used, you must specify the controller ID and slot ID.
The detailed description for each command follows.
perccli /cx[/ex]/sx show
This command shows the summary of the physical drive for a specified slot in the controller.
Input example:
perccli /c0/e0/s4,5 showperccli /cx[/eall]/sall show
This command shows the summary information for all the enclosures and physical drives connected to the controller.
Input example:
perccli /c0/eall/sall showperccli /cx[/ex]/sx|sall show all
This command shows all information of a physical drive for the specified slot in the controller. If you use the all option, the command shows information for all slots on the controller. x stands for a number, a list of numbers, a range of numbers, or all numbers.
Input examples:
perccli /c0/e3/s0-3 show all perccli /c0/e35/sall show all
NOTE: The perccli /cx/sx show all command shows tape drives information.
perccli /cx[/eall]/sall show jbod
This command shows the summary information for all the enclosures and physical drives connected to the controller. If you use the JBOD option, the command shows all Non-RAID disk(s) displayed in JBOD list. If physical disk is Non-RAID, type is set as JBOD and state as Online. ID displays the target ID Non-RAID disks.
Input example:
perccli /c0/eall/sall show jbodperccli /cx[/ex]/sx show jbod
This command shows the summary of the physical drive for a specified slot in the controller.
Input example:
perccli /c0/e0/s4,5 show jbod Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\