- Notes, cautions, and warnings
- Overview
- Accessing the command prompt
- Working with the PERC Command Line Interface tool
- System commands
- Controller commands
- Drive commands
- Virtual drives commands
- Add virtual drives commands
- Delete virtual drives commands
- Delete Non-RAID disks
- Virtual drive show commands
- Preserved cache commands
- Change virtual drive properties commands
- Virtual drive initialization commands
- Virtual drive erase commands
- Virtual drive migration commands
- Virtual drive consistency check commands
- Background initialization commands
- Virtual drive expansion commands
- Foreign configurations commands
- BIOS-related commands
- Drive group commands
- BBU commands
- Enclosure commands
- PHY commands
- Logging commands
- PERC CLI command examples
- Getting a complete list of CLI commands
- Checking controller availability
- Viewing controllers
- Viewing free space information
- Viewing disk1 information
- Viewing controller, virtual disk, and drivers information
- Checking for preserved cache
- Deleting preserved cache
- Viewing expansion information
- Viewing the foreign configuration
- Importing the foreign configuration
- Viewing BBU information
- Viewing physical drive details for the specified slot in the controller
- Viewing the boot drive for the controller
- Setting virtual drive as boot drive
- Locating a drive
- Stopping a locate operation
- Snapdump commands
- Getting help
Dell EMC PowerEdge RAID Controller CLI Reference Guide
Rebuild drives commands
The following commands rebuild drives in the PERC Command Line Tool:
perccli /cx[/ex]/sx pause rebuild perccli /cx[/ex]/sx resume rebuild perccli /cx[/ex]/sx show rebuild perccli /cx[/ex]/sx start rebuild perccli /cx[/ex]/sx stop rebuild
NOTE: If enclosures are used to connect physical drives to the controller, specify the enclosure ID in the command.
The detailed description for each command follows.
perccli /cx[/ex]/sx pause rebuild
This command pauses an ongoing rebuild process. You can run this command only for a drive that is currently rebuilt.
Input example:
perccli /c0/s4 pause rebuildperccli /cx[/ex]/sx resume rebuild
This command resumes a paused rebuild process. You can run this command only when a paused rebuild process for the drive exists.
Input example:
perccli /c0/s4 resume rebuildperccli /cx[/ex]/sx show rebuild
This command shows the progress of the rebuild process in percentage.
Input example:
perccli /c0/s5 show rebuildperccli /cx[/ex]/sx start rebuild
This command starts a rebuild operation for a drive.
Input example:
perccli /c0/s4 start rebuildperccli /cx[/ex]/sx stop rebuild
This command stops a rebuild operation. You can run this command only for a drive that is currently rebuilt.
Input example:
perccli /c0/s4 stop rebuild Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\