Skip to main content
Contact Us

Dell PowerEdge RAID Controller 10 User’s Guide PERC H345, H740P, H745, and H840 Series Controllers

PDF

Convert to Non-RAID disk

To assign a disk from the HII Configuration Utility, perform the following steps:

  1. Enter the Dell PERC 10 Configuration Utility. See Navigating to Dell PERC 10 configuration utility.
  2. Click Main Menu > Physical Disk Management.
    The list of physical disks appears.
  3. Select the physical disk.
  4. From the Operations drop-down menu, select Convert to Non-Raid disk.
  5. Click Go.
    A screen appears asking if you are sure you want to perform the operation.
  6. Select the Confirm option.
  7. Click Yes.
    The disk is created successfully.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\