Skip to main content
Contact Us

Dell PowerEdge RAID Controller 10 User’s Guide PERC H345, H740P, H745, and H840 Series Controllers

PDF

Installing the firmware using DUP

  1. Navigate to www.dell.com/support/home.
  2. Locate your controller.
  3. Download the DUP.
    1. For Window/iDRAC update, download Windows executable file.
    2. For Linux update, download .bin file.
    NOTE:For VMware, firmware should be updated through iDRAC or the PERC CLI utlitily.
  4. Install the DUP.
    1. For Windows, run the executable in Windows environment.
    2. For Linux, run .bin file in Linux environment.
    3. For iDRAC, navigate to system iDRAC > Maintenance > System Update, upload Windows executable, and then install.
      NOTE:
      • Firmware downgrade from version 50.3.0-1022 or later to the older version is not supported via DUP.
      • Firmware downgrade from version 50.5.0-1750 to earlier versions is not supported while the controller is in eHBA mode.
      • Firmware downgrade from version 50.5.1-2633 to earlier versions is not supported while the controller is in OpenManage Secure Enterprise Key Manager mode.
      • PERC H345 and H745 supports firmware version 50.9.1-2905 or later.
      • PERC 745P MX supports firmware version 50.3.0-1512 or later.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\