- Notes, cautions, and warnings
- Overview
- Accessing the command prompt
- Working with the PERC Command Line Interface tool
- System commands
- Controller commands
- Drive commands
- Drive show commands
- Drive Clear commands
- Set drive state commands
- Spin up drive commands
- Locate drive commands
- Power saving commands
- Drive security commands
- Drive erase commands
- PSID erase commands
- Rebuild drives commands
- Replace drive commands
- Drive performance monitoring commands
- SPDM commands
- Hot spare drive commands
- Drive recovery commands
- Drive operation commands
- Delete non-RAID disks
- SMART commands
- Virtual drives commands
- Foreign configurations commands
- Drive group commands
- Energy Pack commands
- View energy pack information
- Enclosure commands
- PHY commands
- Logging commands
- PERC CLI command examples
- View complete list of CLI commands
- Check controller availability
- Show controllers count
- View free space information
- View diskgroup1 information
- Expand a virtual drive
- View Virtual Disk Expansion Information
- Add a virtual drive
- Expand a disk group
- View controller, virtual disk, and drivers information
- Check for preserved cache
- Delete preserved cache
- View the foreign configuration
- View physical drive details for the specified slot in the controller
- Locate a drive
- Stop a locate operation
- Snapdump commands
- PERCCLI2 commands with esxcli plugins
- Getting help
- Documentation resources
Dell PERC13, PERC12, and HBA465 Series Controller Card Command-Line Interface Reference Guide
PERC CLI command examples
You can use
the Dell PowerEdge RAID Controller (PERC) Command Line Interface (CLI)
to manage RAID controllers, configure PERC cards, and perform a variety
of controller and enclosure specific operations.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\